Related Manuals for Orion SPECTRA HP
Summary of Contents for Orion SPECTRA HP
- Page 1 MODEL SPECTRA HP v.20 SERIAL # 2007-8899999 2270 Industrial boul. , Montreal (Laval), Canada, H7S 1P9 Tel.: (450) 667-9769, Fax: (450) 667-6320...
- Page 2 INSTRUCTION MANUAL FOR ALL INQUIRIES PLEASE CONTACT OUR LOCAL DISTRIBUTOR FOR NORTH AMERICA ONLY 1-800-333-6556...
- Page 3 3)Subassembly ( see PART LIST ) SAFETY: ORION'S stretch wrappers should be operated with caution and common sense as any other industrial equipment. To prevent injury and/or electrical shocks, careful operation of the machine and awareness of its many automatic functions is required.
- Page 4 All-enclosed chains & electronics Available Options: SPE-001 Extended tower for loads up to 110” tall (ships with tower hinged/tilted) SPE-010 Heavy-duty ramp for loading with pallet-jack or electric walkie *ORION PACKAGING RESERVES RIGHTS TO CHANGE THIS SPECIFICATION AT ANY TIME WITHOUT NOTICE...
- Page 5 Any transport The roping bar damage cannot be claimed to Orion Packaging Inc. Items that are vulnerable to damage and must be inspected are The roping bar is rotating around the shoulder screw (dwg...
- Page 7 Note: For VFD adjustment, please contact Orion Packaging service department...
-
Page 9: Machine Operation
MACHINE OPERATION POWER SWITCH Located on the panel door or side of the panel box, the lockable power switch has two settings: ON - connects a power source to the machine OFF - disconnects the power source. START AND EMERGENCY STOP SWITCHES The START switch is used to start the cycle once the load is on the turntable. - Page 10 5- WRAPPING SPIRAL ; UP & DOWN OR UP 8- TABLE SPEED ONLY The option has two setting, fix or adjustable. When set to Press button #5 on the keypad to switch from UP ONLY to fix, the turntable speed is constant and can not be change UP &...
-
Page 11: Loading The Film
LOADING THE FILM ADDITIONNAL SPACER WASHER The film roll can be loaded on the carriage mandrel from (IF NEEDED ONLY) either end of the roll. When using tacky film, please verify that the inward tacky surface of the film is inward on the The roll of film may be slightly different from time to time, load. - Page 12 PROXIMITY SENSOR ADJUSTMENT Occasionally the Feed Back Proximity Sensor may need some adjustment. The position of the feed back proximity sensor against the cam is shown on drawing # 419139 and on Figure 6. Adjustment instructions: Power down machine. Remove the carriage cover. Unbolt the two nuts holding the proximity switch - item # 1.
-
Page 13: Machine Maintenance
MACHINE MAINTENANCE All general information about machine maintenance is based on Externally: by lubricating and wiping the chain drive with oily cloth. normal machine working conditions: indoor, moderate dust and low The frequency of lubrication depends on entirely upon the usage of moisture environment, and maximum rotation of 32 RPM of the machine and environment in which the machine is placed (dust, turntable/rotary arm. - Page 14 SEMI-AUTOMATIC STANDARD ASSEMBLY PART LIST Note : * Quantity listed in order of part number ** The names given to the parts are generic...
Need help?
Do you have a question about the SPECTRA HP and is the answer not in the manual?
Questions and answers