Table of Contents
Advertisement
Netcam(W)_SNC-L200(W)
System Configuration
Alarm Notification
Capture images and send them via E-mail when a motion is detected by PIR.
1
Service: Set whether to enable this service. Select Enable to use the Alarm Notification.
SMTP server address: Used to send E-mail to the address on SMTP (Simple Mail Transfer
2
Protocol)Server. Enter the SMTP server address and your personal
e-mail address (only the part after '@'). ex) smtp.samsung.com
3
Authentication Login: Select the Enable to use the log-in screen. It is recommended to
select the Enable.
4
User ID: Enter the User ID of the sender 's E-mail address when using the Authentication Login.
5
Password: Enter the User Password of the sender 's E-mail address when using the
Authentication Login.
6
Sender(E-mail): Enter the sender 's E-mail address.
7
E-mail address 1~4: Enter up to 4 mail addresses to receive capture images.
Image Count: Set the number of images to be transmitted upon Alarm Notification.
8
"Pre Alarm" means the number of images to be sent before the Alarm, and
"Post Alarm" is the number of images to be sent after the Alarm. Up to 5
images can be sent in a 0.5-second interval.
9
PIR is linked with Preset : Select Enable if you want to move the camera lens to the
specified Preset 1 when an alarm occurs.
58
1
2
3
4
5
6
7
8
9
Network Configuration
< Network Configuration Sub Menu >
- Network Configuration: Set the Static IP or the DHCP.
- PPPoE(ADSL): Set the PPPoE(ADSL).
- UPnP Configuration: Set the Port Forwarding and the Display shortcut Icon in My
Network Places.
- Network Ports: Set the HTTP Port.
- View Network Status: Display the network status of the current system.
- Network Status Notification: Send information on allocated IP addresses such as the
DHCP and the PPPoE.
- DDNS Configuration: Set the DDNS.
Netcam(W)_SNC-L200(W)
59
Advertisement
Table of Contents
