Johansson Profino Revolution Lite User Manual page 10

PROFINO REVOLUTION LITE (REF. 6714)
ADVANCED
DISPLAY READOUT
Note: You can convert any single input Channel, to any output Channel position (including
output S-channels). But you can only convert a group of input channels to a group of output
channels with the same channel spacing.
Some examples:
21:23 → 31:33
07:07 → S15:15
07:07 → S35:35
07:08 → S35:36
10
SETTINGS
EXPLANATION
The
English, Italian, Spanish or French.
Tap REGION to check to which region/country the
Profiler Revolution is set. To change the
region/country, a hard reset is required (see
instructions above (cfr. REGION/COUNTRY SETTINGS).
Define DC VOLTAGE for the inputs, choose between
12V or 24V. This is a global setting for all inputs, each
input can then be switched between OFF or this value.
(cfr. STEP 2). All countries are set by default on 24V,
except UK which is set by default on 12V.
The filter bandwidth can be changed from -2000 kHz to
0 kHZ in steps of 250 kHz.
This allows you to optimize the bandwidth of your filter.
For instance, a European 8 MHz channel can be
changed from 6 to 8 MHz. The default setting is -750
kHz, which is an optimal setting in 95% of the cases.
S-Band channels can be activated in Advanced Mode.
By default, they are not activated.
See NOTE below for more explanation.
Tap FW VERSION to check the firmware version of the
device.Tap SERIAL NUMBER to check the serial number
of the device. To format the SD CARD, tap FORMAT
CARD.
Can be converted because groups of channels have same channel spacing
Can be converted because single channel conversion
Can be converted because single channel conversion
(Even though channel spacing and bandwidth is different)
Can't be converted because groups of channels have different channel spacing
language of the Profiler Revolution can be set to