EUFAB CB-20 Manual page 10

6.2.5 REMOVING THE CHARGER
Set the power switch to the "OFF" position.
CAUTION
First pull the plug out of the socket and observe
the sequence for disconnection. This prevents
sparks from forming. Since charging generates
a detonating gas, this is particularly important
for the sake of your safety.
Disconnect the charger from the mains power supply.
Next, remove the black negative (-) cable. Now, remove the
red positive cable (+) from the positive pole of the battery.
Let the battery cool down.
Only for open batteries: Fill the cells with distilled water
up to the level specifi ed by the battery manufacturer. Close
the battery cells with the stoppers.
6.3 TROUBLESHOOTING
6.3.1 IN CASE OF SHORT CIRCUIT
The green 30 A fl at fuse can blow if the pole clamps touch
each other when the unit is switched on.
In this case, switch the battery charger off and disconnect the
mains plug from the socket. Pull the fuse out of the holder
and replace it with a new, equivalent fuse.
Figure 5: 30 A fuse
6.3.2 IN CASE OF OVERVOLTAGE
In the event of overvoltage in the power supply system, the
5 A glass fuse may blow. In this case, switch off the battery
charger and disconnect the mains plug from the socket.
Unscrew the fuse holder. Replace the fuse with a new
equivalent one
(Ø 5 x 20 T 5 A).
Figure 6: T 5 A fuse
10
6.3.3 OTHER FAULTS
If other faults or defects occur, contact our customer service
department (see section 9) or consult a specialist electrical
workshop.
Never open the device yourself to attempt
to repair it. This is potentially fatal!
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
The battery charger is maintenance-free when used in
accordance with the intended purpose.
7.2 CARE
Clean the pole callipers after the charging process is
completed. Remove all splashed battery acid from the pole
callipers to prevent corrosion. Clean the device carefully with
a dry cloth. Do not use liquids or chemical cleaning agents.
Never submerge the device in liquid. Never allow liquids to
run over the device or to get inside.
Properly roll up the cable before storing the device to prevent
damage to the cables and the device. Store the device in a dry
and clean location.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
The packaging is made up of environmentally
friendly materials which may be disposed of
via your local recycling points.
Do not put electrical devices into the
household waste.
Electrical and electronic scrap must be
collected separately and disposed of in an
environmentally responsible manner for
recycling. Please contact your community or
city administration regarding disposal options
for electronic scrap.
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com