Using The Charge Card; Settings With The Charge Card - V-ZUG Card-System 1 Operating Instructions Manual

3 Operation
The appliance continues after 3 seconds. If the card has not yet been removed from the
card reader:
Remove card
–
▸ Remove the card from the card reader.
Returning credit to the user card for appliance 2, double machine
To debit the user card for appliance 2 hold down the
button. Then proceed as with appliance 1.
3.10

Using the charge card

Charging the user card
▸ Briefly press the
Please select appliance
– ...
▸ Briefly press the
Please insert card
–
▸ Hold the charge card to the card reader.
The charge authorisation code on the card is checked.
– If the charge code on the charge card is 0, then
pears in the display.
The appliance continues after 3 seconds.
– Press button 1 to save data appears in the display.
1
▸ Press the button to confirm.
Charge
–
– then Please insert card to charge
▸ Hold the user card to the card reader.
– New credit amount xxx.xx appears in the display.
– A buzzer sounds briefly to confirm.
The appliance continues after 3 seconds. If the card has not yet been removed from the
card reader:
Remove card
–
If the credit on the user card is the same as or greater than the amount charged,
Card already charged
If no other user cards are charged, the display goes out after about 10 seconds.
End
–
3.11

Settings with the charge card

The procedure described below is explained on the basis of model 82A.
▸ Hold down the
Please select appliance
▸
▸ After 3 seconds,
▸ After 10 seconds,
12
appears in the display and the LED is illuminated.
1
button.
appears in the display and the LEDs are illuminated.
1
button again.
appears in the display.
appears in the display.
appears in the display.
appears in the display.
appears in the display.
1
button.
appears in the display and the LEDs flash.
Return credit
Setting
2
button instead of the
Save charge code
appears in the display.
appears in the display.
1
ap-