Advertisement
4100-6047 and 4010-9914 Building Network Interface Card Installation and Programming Manual
Setting DIP switch SW1
Dual Inline Package (DIP) Switch SW1 is used to set the BNIC eSlave address as identified in the ES Panel Programmer job. The address is set with the
card in its normal orientation (connectors up) as shown in the mounting instructions (see Figure 6).
Switch
Position
SW1-1
ON
OFF
SW1-2
ON
OFF
through SW1-8
page 4
Table 2: BNIC DIP switch functions
Function
Sets the card to "online" and allows the card to operate
normally.
Sets the card "offline" which stops all communication to
the FACP.
Set the BNIC eSlave address. Refer to Figure 4 for a
complete list of switch settings for all possible card
addresses.
Figure
Figure 3: BNIC DIP switch
579-949 Rev. D
Advertisement
