Advertisement
4100-6047 and 4010-9914 Building Network Interface Card Installation and Programming Manual
Configuring the BNIC
Follow these steps to configure the BNIC:
1.
Right-click on the BNIC icon in the Hardware tree view.
2.
Select and open the Properties option. This will open the BNIC window.
3.
Configure the Card Properties tab by setting:
-
The Card Address
-
The Card Custom Label
-
The Card Alternate Custom Label
-
The Unit
-
The Box
-
The Bay
-
The Location
Note: For additional information on card properties consult the ES Programmer Manual.
Select the BNIC IP Settings tab.
4.
Configure the BNIC IP Settings tab by setting:
5.
-
The IP Address.
• Use the Dynamic Host Configuration Protocol (DHCP) option to have the Building Network automatically assign an IP address
to the card.
• Select the Use the following address option if you want to set the IP address manually and enter a Static IP address.
-
For Static IP Addresses:
• If you are using a Customer LAN, refer to the worksheet information on
customer provided addresses.
page 11
Figure 12: Accessing the card properties
Figure 13: Card properties tab
Before You Approach Your MIS/IT Department
for
579-949 Rev. D
Advertisement
