Date/Time - Worldcast Systems RELIO User Manual

Relio 4.2.x User Manual – 07/2015

3.11. Date/Time


If you are going to use the Relio with an SNTP connection configure the NTP settings, then the time zone. The
rest of the parameters will adjust themselves automatically.

If setting time and date manually, set the time zone first – changing the time zone affects the time and date
displayed in those boxes.

Any changes on this page will cause a restart of the system software – time and date changes affect many
areas of the system, a restart is necessary with any change.
Set system date :
The user may update both date (year/month/day) and time (hour/minute/second)
Set system time zone: to update the geographical time zone
The user selects the geographical zone from the list. Important to have this set correctly when using an NTP
server.
Network Time Protocol: NTP update (Network Time Protocol)
The user can enter a time server address to update the equipment's internal clock automatically. Make
sure this address can be reached by the unit; specifically, the gateway must be properly set. Specify
whether it should be synchronized continuously or periodically. For periodic synchronization, indicate what
time the daily synchronization should occur (between 0 and 23).

Remember to click the 'Update' button in each section to lock in any changes.
Head Office : Parc d'activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
Page 21
contact@worldcastsystems.com – www.worldcastsystems.com