System Settings - Worldcast Systems RELIO User Manual

Relio 4.2.x User Manual – 07/2015

3.8. System Settings

 Definition of the IP configuration:
o
Ethernet configuration mode
It is preferable to configure the Primary network interface ENET1 with static parameters.
Should the unit be set to DHCP, you may lose the ability to know what IP address it has
and thus access it on the network. If this occurs, you must return to static IP settings
using either the serial connection or local KVM, as described in section 3.4 of this
manual, and in the Quick Start guide.
o
Static Ethernet configuration
Enter the static IP parameters in this window. IP address and mask are essential,
gateway is important if the Relio is to communicate outside its own subnet. The
secondary interface can be used as a backup interface if the Ethernet fail-over function is
enabled.
o
DNS Servers: DNS configuration. Very important if the Relio is to send e-mails using an
alpha server name (i.e. smtp.server.com as opposed to 54.32.156.67).
Head Office : Parc d'activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
Page 18
contact@worldcastsystems.com – www.worldcastsystems.com