M35(t) / M65(t)
Setups
Setups
Installation
CAUTION : Before you begin, make sure your mixer-amplifier is disconnected from the power source, with
the power switch in the "OFF" position and all level controls turned completely down (counterclockwise).
You may stack mixer-amplifiers without using a cabinet or you may place a single mixer-amplifier
on a surface with 12-inches (about 30cm) of air space around the unit for convection cooling.
Wiring guide
Choose input wire and connectors
We recommends using pre-built or professionally wired balanced line. 22 to 24 gauge cables.
Figure 2.1 shows connector pin assignments for wiring. The RCA input connections can also be
used for unbalanced inputs.
[ Figure 2.1 Input wire and connectors ]
5