Tech Controllers EU-F-2z v2 Quick Manual

TECH company ensures to the Buyer proper operation of the device for the period of 24 months from the date of sale. The
Guarantor undertakes to repair the device free of charge if the defects occurred through the manufacturer's fault. The device should be
delivered to its manufacturer. Principles of conduct in the case of a complaint are determined by the Act on specific terms and conditions
of consumer sale and amendments of the Civil Code (Journal of Laws of 5 September 2002).
CAUTION! THE TEMPERATURE SENSOR CANNOT BE IMMERSED IN ANY LIQUID (OIL ETC). THIS MAY RESULT IN DAMAGING THE
CONTROLLER AND LOSS OF WARRANTY! THE ACCEPTABLE RELATIVE HUMIDITY OF THE CONTROLLER'S ENVIRONMENT IS 5÷85%
REL.H. WITHOUT THE STEAM CONDENSATION EFFECT. THE DEVICE IS NOT INTENDED TO BE OPERATED BY CHILDREN.
The costs of unjustifi able service call to a defect will be borne exclusively by the buyer. The unjustifi able service call is defi ned as a
call to remove damages not resulting from the Guarantor's fault as well as a call considered unjustifi able by the service after diagnosing
the device (e.g. damage of the equipment through the fault of the client or not subject to Warranty), or if the device defect occurred for
reasons lying beyond the device.
In order to execute the rights arising from this Warranty, the user is obliged, at his own cost and risk, deliver the device to the Guarantor
along with a correctly fi lled-in warranty card (containing in particular the sale date, the seller's signature and a description of the defect)
and sales proof (receipt, VAT invoice, etc.). The Warranty Card is the only basis for repair free of charge. The complaint repair time is
14 days.
When the Warranty Card is lost or damaged, the manufacturer does not issue a duplicate.
......................................
seller's stamp
SAFETY
Before using the device for the first time the user should read the
following regulations carefully. Not obeying the rules included in
this manual may lead to personal injuries or controller damage.
The user's manual should be stored in a safe place for further
reference. In order to avoid accidents and errors it should be
ensured that every person using the device has familiarized
themselves with the principle of operation as well as security
functions of the controller. If the device is to be sold or put in a
diff erent place, make sure that the user's manual is there with
the device so that any potential user has access to essential
information about the device.
The manufacturer does not accept responsibility for any injuries or
damage resulting from negligence; therefore, users are obliged to
take the necessary safety measures listed in this manual to protect
their lives and property.
EU DECLARATION OF CONFORMITY
Hereby, we declare under our sole responsibility that EU-F-2z v2
manufactured by TECH, head-quartered in Wieprz Biała Droga 31, 34-
122 Wieprz, is compliant with Directive 2014/53/EU of the European
parliament and of the Council of 16 April 2014 on the harmonisation of the
laws of the Member States relating to the making available on the market
of radio equipment, Directive 2009/125/EC establishing a framework for
the setting of ecodesign requirements for energy-related products as
well as the regulation by the MINISTRY OF ENTREPRENEURSHIP AND
TECHNOLOGY of 24 June 2019 amending the regulation concerning
the essential requirements as regards the restriction of the use of
certain hazardous substances in electrical and electronic equipment,
implementing provisions of Directive (EU) 2017/2102 of the European
Parliament and of the Council of 15 November 2017 amending Directive
2011/65/EU on the restriction of the use of certain hazardous substances
in electrical and electronic equipment (OJ L 305, 21.11.2017, p. 8).
For compliance assessment, harmonized standards were used:
PN-EN IEC 60730-2-9 :2019-06 art. 3.1a Safety of use
PN-EN 62479:2011 art. 3.1 a Safety of use
ETSI EN 301 489-1 V2.2.3 (2019-11) art.3.1b Electromagnetic
compatibility
ETSI EN 301 489-3 V2.1.1:2019-03
compatibility
ETSI EN 300 220-2 V3.2.1 (2018-06) art.3.2 Effective and coherent use
of radio spectrum
ETSI EN 300 220-1 V3.1.1 (2017-02) art.3.2 Effective and coherent use
of radio spectrum
Wieprz, 17.06.2021
WARRANTY CARD
art.3.1 b Electromagnetic
WARNING
• The device should be installed by a qualified electrician.
• The regulator is not intended to be used by children.
• It is a live electrical device. Make sure the regulator is
disconnected from the mains before performing any
activities involving the power supply (plugging cables,
installing the device etc.).
• Any use other than specified by the manufacturer is
forbidden.
We are committed to protecting the
environment.
devices imposes an obligation of providing
for environmentally safe disposal of used
electronic
Hence, we have been entered into a
register kept
Environmental Protection. The crossed-
out bin symbol on a product means that
the product may not be disposed of to
household waste containers. Recycling of
wastes helps to protect the environment.
The user is obliged to transfer their used
equipment to a collection point where all
electric and electronic components.
TECHNICAL DATA
Power supply
Maximum power consumption
Humidity measurement range
Room temperature adjustment range
Power supply
Operation temperature
Maximum power consumption
Potential-free cont. nom. out. load
Operation frequency
Max. transmission power
* AC1 load category: single-phase, resistive or slightly inductive AC
load.
** DC1 load category: direct current, resistive or slightly inductive
load.
..............................
date of sale
Manufacturing
components and
by the Inspection For
EU-F-2z v2
230V ± 10% / 50Hz
0,5W
10-95% RH
50C ÷ 350C
EU-MW-3
230V ± 10% / 50Hz
50C ÷ 500C
<1W
230V AC / 0,5A (AC1) *
24V DC / 0,5A (DC1) **
868MHz
25mW
electronic
devices.