Making A Copy - Samsung SF-3100 User Manual

Installation

Making a Copy

Copy a document to verify proper machine operation. You can copy single or multiple page
documents.
1
Turn the page face down and insert it into the document feeder.
2
Adjust the document guide to match the width of the document.
3
Feed the document into the machine. The automatic document feeder pulls
in the page. If necessary, press RCV.Mode $! Contrast to choose the desired
contrast for the document.
4
Press
The display shows 'NUMBER OF COPIES'.
•
If you want one copy at preset copy rate,
•
If you want two or more copies,
•
If you want to change copy rate,
Enter. You can scale the document from 75% to 100% by entering the number, and
this change will remain on the non-volatile memory and affect every copy you are
going to make. The default copy rate is 97%.
5
Press (Start/Enter) when the number on the display is correct.
Copying begins. The display shows the page number that is being copied.
When the machine runs out of paper, supply additional paper and press
Start/Enter, then remaining copy will resume.
12
(Copy).
press Start/Enter and enter the number.
select COPY RATE by pressing !➛! or ❿ and Start/
press Copy again and skip step 5 below.