Table of Contents
Advertisement
5
Quick Start (en)
Before putting the VS80 into operation there are two steps that must be performed immedi-
ately after connecting the probe to the main unit:
1.
Update the VS80 firmware, as explained in Section 14.
2.
For visual probes only: Select the probe that you intend to use from the Settings menu
list, as explained in Section 8. This does not apply when connecting an IR probe.
Failure to perform these steps will cause the VS80 to misidentify the connected probe.
1. If the battery status icon is showing a low charge, or if the unit will not
power up, connect the VS80 to an AC power source using the supplied AC
adaptor/charger, the charger connects to the USB port located on the top
of the display unit (see Section 10 for details).
2. Ensure that a micro SD card is inserted in the slot located in the right side
compartment.
3. Carefully connect the camera probe as detailed below:
Figure 5.1 Connecting the probe to the monitor unit
• Align the white dot on the probe connector with the dot on the display
connector.
• Carefully plug the probe into the display unit.
• Tighten the connecting collar to secure the probe connection.
• As mentioned, select the probe from the Settings menu list. See Sec-
tion 8.
4. Remove the protective lens cap from the camera probe.
5. Long press the power button, the FLIR logo will appear.
6. The camera image will then appear with touch-screen icons, battery status
icon, date/time, and color bar graph (IR camera).
#NAS100101; r. AB/85156/85156; en-US
CAUTION
10
Advertisement
Table of Contents
