Table of Contents
Advertisement
3
Introduction
3.1 Overview
Thank you for selecting the VS80 High Performance Videoscope kit. The
VS80 kit is a rugged, waterproof video inspection system that includes the
VS80 Videoscope, a detachable camera probe, and accessories.
The VS80 works with a variety of cameras probes as listed in Section 3.3 and
3.4 below. VS80 probes are especially designed to perform well in difficult to
reach locations and areas unsafe to approach. The probes provide sharp vid-
eo and still images and can be safely submerged in fluids, as specified in the
separate instructions provided with each probe.
Before putting the VS80 into operation there are two steps that must be performed immedi-
ately after connecting the probe to the main unit:
1.
Update the VS80 firmware, as explained in Section 14.
2.
For visual probes only: Select the probe that you intend to use from the Probe Selec-
tion Settings menu list, as explained in Section 8. This does not apply when connect-
ing an IR probe.
Failure to perform these steps will cause the VS80 to incorrectly identify the connected
probe.
The VS80 is battery operated and its internal lithium battery can be charged
by connecting the VS80 to an AC source using the supplied USB AC adaptor/
charger (see Section 10).
Still images and videos are stored on the supplied micro SD card, inserted in
the VS80 right side compartment. Stored media can be downloaded to a PC
using the USB-C port (see Sections 9 and 13).
#NAS100101; r. AB/85156/85156; en-US
CAUTION
4
Advertisement
Table of Contents
