The VS80 user manual and additional translations of this probe manual are available from the support site (see the Support section). Please update the VS80 firmware before use, as explained in the VS80 manual. This will ensure optimal functionality and full compat- ibility with your camera probe.
Page 3
VS80CIR—21 Thermal IR Camera Probe The VS80CIR-21 offers a Lepton 3.5 IR camera with a 3.3 ft (1 m) probe. The VS80 displays the camera image and the temperature of targeted surfaces and offers s selectable display palette, a tem- perature alarm, and other features.
Connecting the Probe The steps below explain how to safely connect the probe to the VS80 monitor. Always turn the VS80 power off before replacing the probe. 1. Align the white dot on the probe connector with the white dot on the monitor connector.
0.84 in (21.3 mm) for VS80C2–49–1RM Probe length 3.3 ft (1 m) Side-view camera VS80C2–49–1RM only LED Worklights Worklights are controlled from the VS80 Four forward and two side worklights on VS80CHD-55–1RM and VS80C55–1RM Five forward and one side worklight on VS80C2– 49–1RM Operating temperature 32 to 140℉...
Page 6
Storage temperature –4 to 140℉ (-20 to 60℃) Relative Humidity 10 to 95 % non-condensing Approved liquids for digi- Approved for use in brake and transmission fluid, tal camera probes diesel fuel, unleaded gasoline, engine oil, and CPC hydraulic fluid (46AWS). This does NOT ap- ply to the IR camera probe VS80CIR-21 Ingress rating Probe tip and body: IP 67 (IEC 60529)
Warranty and Support Three-Year Limited Warranty This product is protected by FLIR’s 3-Year Limited Warranty. Visit www.flir.com/testwarranty to read the 3-Year Limited Warranty document. CUSTOMER SUPPORT Customer Support Telephone List https://support.flir.com/contact Repair, Calibration, and Technical Support https://support.flir.com #NAS100105; r. AB/83753/84877; en-US...
Need help?
Do you have a question about the VS80 and is the answer not in the manual?
Questions and answers