Vega ASV-1 Operating Manual page 14

Vega ASV-1 Operating Manual Page 14
ASI Span:
Select the maximum airspeed that you want the airspeed tape to display. This can give you increased display resolution.
ASI In View:
Adjust this setting to set the amount of tape to view. For example, setting this value to 30% and your "ASI SPAN" to 250
will result in the tape showing 75 on the display at a time.
Vne Speed: (Max Exceed Speed)
Enter you maximum speed you aircraft should not exceed.
Vne (Max exceed speed)
Vno Speed: (Max Maneuvering Speed)
Enter your maximum maneuvering speed.
Vno (Max maneuvering speed)
Vfe Speed: (Max Flap Speed)
Vfe (Max flap speed)
Enter the maximum speed that is permissible with the flaps extended.
Vs1 Speed: (Min Safe Speed, Normal)
Enter your minimum safe speed for normal flight of your aircraft
Vs1 (Min safe speed, normal)
Vs0 Speed: (Min Safe Speed, Landing)
Enter your minimum safe speed for landing your aircraft
Vs0 (Min safe speed, landing)
Vs Alarm:
This enables or disables Vs Alarm.
Vne Alarm:
This enables or disables the VNE alarm.
Cal:
During the factory calibration a factor has been determined and entered here that will give you accurate airspeed, pro -
vided your pitot tube is not influenced by pressure effects caused by airflow around your airframe. The calibration is dis -
played in % of the reading, you can increase or decrease the reading if required to help cancel out under or over reading
of the airspeed indicator on your aircraft.
Position:
Select whether you want the airspeed display on the top or on the bottom of the main display (VSI Tape display only).
Tape:
Select the desired display tape (Altitude, VSI or airspeed). The main display screen will change according to this selec-
tion.