Power Trim And Tilt Switches (Twin Binnacle Type); Trim Tab With Anode - Yamaha LF115 Owner's Manual

distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
UP
DN
1. Power trim and tilt switch
EMU26163
Power trim and tilt switches (twin
binnacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switches, see
pages 61 and 64.
1
DN
UP
1. Power trim and tilt switch
TIP:
On the dual engine control, the switch on the
remote control grip controls both outboard
motors at the same time.
EMU26244

Trim tab with anode

1
EWM00840
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
ZMU04223
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side "A"
in the figure. If the boat tends to veer to the
" (up) trims the
right (starboard side), turn the trim tab end to
the starboard side "B" in the figure.
ECM00840
NOTICE
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it
will become ineffective as an anode.
ZMU04601
1. Trim tab
Components
WARNING
B
1
3
2
A
ZMU02525
29