General Information; Safety Notes - Blue Wave EASY CLEAN 200 Instruction Manual

2. GENERAL INFORMATION

• This manual provides information relating to the installation, utilization, and maintenance of our
filtration system. We recommend that you read this manual in its entirety and keep it for future
reference.
• The pump included with the filtration system is a horizontal, centrifugal pump. For the pump to
function correctly, the water temperature must not exceed 35°C (95°F). The materials used in the
pump have undergone stringent hydraulic testing and electrical inspections.
• The filter tank included in the filtration system consists of a high-grade polypropylene (PP). It is
manufactured as a single unit (both fully corrosion resistant and resistant to commercially available
swimming pool chemicals). Prerequisite: Compliance with the standard recommended specifications
for the pH- and chlorine values. The filter tank is equipped with a tank drainage system. The filter
tank comes ready to attach with an approved filter pump.
• Read this manual carefully before installation. The filtration system and pump must be installed in
accordance with all federal and local codes and standards in effect for the area of installation.
• We decline all responsibility for the consequences of failure to comply with the installation
instructions. We recommend that you comply with the power source instructions to avoid
overloading the pump motor and/or electric shock.
• Safety notes and information boxes should ALWAYS be observed.

3. SAFETY NOTES

• Your filter pump was constructed and tested before leaving the manufacturing plant in operational
condition. In order to maintain this condition and ensure safe operation, the user should observe
the notes and product information contained in this technical manual. If there is any indication that
the safe operation is no longer possible, the device should be disconnected from the power supply
immediately and secured against accidental use. Below is a list of cases when the safe usage of the
filter-pump is no longer.
This is the case when:
• The device has visible damage.
• The device no longer appears functional.
• After long periods of storage in poor conditions.
NOTE: If the power cord or other parts of this equipment are damaged, they have to be replaced by
the manufacturer, its service agent, or a similarly qualified person.
5