Storage & Winterization; Troubleshooting - Blue Wave EASY CLEAN 200 Instruction Manual

16. CLEANING COTTONTAIL
c. Blue Wave
®
will not be responsible for damage caused to the CottonTails
of the internal components of the filter tank where a clarifier or other chemical additives that bond
to particulate matter have been used in the pool.
17. STORAGE & WINTERIZATION
1. Disconnect the filter-pump assembly from the pool.
2. Drain the tank and the hoses.
3. The filter system must be thoroughly dried before winter storage to prevent freezing and cracking
of the tank or pump components.
4. Store in a dry location protected from frost.

18. TROUBLESHOOTING

WARNING! ALWAYS turn off the power supply to the pump before attempting any of the solutions
outlined below.
Malfunctions
Water pressure is low or
cotton tails look dirty.
Water flow is too low.
Air is in the pump.
Leaking pump.
Pump does not run on
initial start-up
Pump stops running or
will not restart
Causes
The cotton tails have absorbed too much
dirt and debris from the water.
Pump gets too little water.
Poor seal on the intake fitttings of the
pump.
Seal is worn out or damaged.
•
Poor power cord connection.
•
Motor shaft is stuck.
•
G.F.C.I. or main circuit breaker tripped.
•
Debris is blocking the impeller.
•
Pump motor is defective.
FILTRATION BALLS (CONT.)
TM
Solutions
Clean the Cottontail
Check the suction line and the water level in the pool.
Tighten the hose clamps and the connection fittings. If
necessary, use Teflon tape. Open the air vent plug.
Replace the pump.
Check the socket and power cord. Place a flathead
screwdriver into the slot at the rear of the motor shaft and
gently turn to free.
•
Switch on the circuit breaker (if it immediately trips again,
there is a defect in the pump or the controls). Fix or replace
the pump. Clean the pump body.
•
Replace the notor or the entire pump.
, the filter tank, or any
TM
filter media.
TM
15