Table of Contents
Advertisement
Cessna Turbo Skylane 182
3.
- Delect the
lap
rate each hinge with thin C/A glue. he
ailerons front surface should lightly con-
tact the wing during this procedure. Ide-
ally, when the hinges are glued in place,
a 1/64" gap or less will be maintained
throughout the lengh of the
wing panel hinge line.
NOTE : he hinge is constructed of a spe-
cial material that allows the C/A to wick
or penetrate and distribute throughout
the hinge, securely bonding it to the wood
structure of the wing panel and lap.
4.
C/A glue
- Turn the wing panel over and delect the
lap in the opposite direction from the oppo-
site side. Apply thin C/A glue to each hinge,
making sure that the C/A penetrates into
both the aileron and wing panel.
- Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the wing or in the lap
hinge area.
4
T-pin
and completely satu-
to the
lap
Instruction Manual.
- Repeat this process with the other wing
panel, securely hinging the aileron in
place
.
- Ater both lap are securely hinged,
irmly grasp the wing panel and aileron to
make sure the hinges are securely glued
and cannot be pulled out. Do this by care-
fully applying medium pressure, trying to
separate the lap from the wing panel. Use
caution not to crush the wing structure.
5.
Note :
Work the aileron up and down sev-
eral times to "work in" the hinges
and check for proper movement.
HINGING THE AILERON
Note : he control surfaces, including the ailer-
ons, elevators, and rudder, are prehinged with
hinges installed, but the hinges are not glued in
place. It is imperative that you properly adhere
the hinges in place per the steps that follow us-
ing a high-quality thin C/A glue.
- Carefully remove the aileron from one of
the wing panels. Note the position of the
hinges.
1.
C/A Hinge
Advertisement
Table of Contents
