Seagull Models Cessna Turbo Skylane 182 Assembly Manual page 19

2.
Rudder servo arm
INSTALLING THE RECEIVER SWITCH
- Install the switch into the precut hole in
the side, in the fuselage.
1.
2.
.
Trim and cut
3.
Switch
Elevator servo arm
hrottle servo arm
3/32" Hole.
INSTALLING THE STOPPER
ASSEMBLY
- Using a modeling knife, carefully cut
of the rear portion of one of the 3 nylon
tubes leaving 1/2" protruding from the
rear of the stopper. his will be the fuel
pick up tube.
- Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
the other end to the nylon pick up tube.
1.
2.
3.
19