Getting Ready; Placing The Rd-700Nx On A Stand - Roland RD-700NX Owner's Manual

Getting Ready

Placing the RD-700NX on a Stand

If you place the RD-700NX on a stand, you must use the KS-G8 (sold separately). When placing the RD-700NX on the KS-G8, place it in the position
shown below.
NOTE
Using the RD-700NX with any other stand may produce an unstable situation, possibly causing the instrument to fall or overturn, and resulting in
injury or damage.
For details on how to assemble the stand, refer to the owner's manual that accompanied the stand.
Seen from the side
Align the seam in the RD-700NX's panel (on the
bottom, near the front) with the corners of the
stand's rubber feet .
Seen from the rear
NOTE
When placing the RD-700NX on the stand, be careful not to pinch your fi ngers between the instrument and the stand.
Align the center Align the center
screw on the screw on the
bottom of the bottom of the
RD-700NX with RD-700NX with
the center of the the center of the
stand . stand .
13