Configuration And Programming; Ms/Tp Network Access Port; Maintenance - KMC Controls FlexStat BAC-19 Series Installation Manual

CONFIGURATION AND PROGRAMMING

To set up the FlexStat from the touchscreen:
1. Push and hold the upper left corner of the
screen (space temperature reading) to start.
2. Select the desired options and values. See the
BAC-19xxxx FlexStat Application Guide
details.
Illustration 13—Screen Menus Access (Default)
NOTE: Options in menus are dependent
on the FlexStat model and selected
application.
Advanced configuration of a FlexStat can be done
through software. See the
FlexStats Data Sheet for the most relevant KMC
Controls tool for additional configuring, program-
ming (with Control Basic), and/or creating graph-
ics for the controller. See the documents or Help
systems for the respective KMC tool for more
information.
BAC-19xxxx FlexStat Installation Guide
for
Settings (Press Space Temp)
Active Cooling Setpoint
Active Heating Setpoint
Fan Auto or (Constant) On
Occupancy Override
Units (°F or C)
Heat/Cool/Auto/Off Mode
BAC-190000 Series

MS/TP NETWORK ACCESS PORT

The MS/TP EIA-485 data port on the bottom of
the cover provides technicians temporary access
to an MS/TP network (not Ethernet) using an
HPO-5551, BAC-5051E, and
the documentation for those products for details.
Illustration 14—MS/TP (EIA-485) Data Port

MAINTENANCE

To maintain accurate temperature and humidity
sensing, remove dust as necessary from the venti-
lation holes in the top and bottom of the case.
To maintain maximum sensitivity of the built-in
motion sensor, occasionally wipe dust or dirt off
the lens—but do not use any fluid on the sensor.
To clean the case or display, use a soft, damp
cloth (and mild soap if necessary).
7
KMC Connect. See
926-019-02C