Wall Mounting - Viessmann VITODENS 200-W B2HE 85 Installation Instructions Manual

Boiler Connections

Wall Mounting

Legend
A Vitodens wall mounting bracket
16
Vitodens 200-W B2HE 85, 120, 150, 199 Installation
Fitting the wall mounting bracket
Following are the installation instructions for the mounting
bracket on each material. See the instructions applicable
to your installation requirements.
Installing the wall mounting bracket
The Vitodens 200-W B2HE can be wall-mounted on a
concrete wall.
Note: The enclosed screws and rawl plugs are only
suitable for concrete. For other construction
materials, use bolts and anchors that are suitable
for 179 lb. (81 kg) loads.
Installation of mounting bracket on brick/concrete wall
1. Mark out the rawl plug holes.
2. Drill holes 7 e in. (7 10 mm) and insert the rawl
plugs supplied.
3. Fit the wall mounting bracket with the screws supplied.
Note: Check the condition of the wall where the boiler is
to be installed. For the suitability of the supplied
rawl plugs for various building materials, see the
manufacturer's instructions.
For other construction materials, use fixing
materials with sufficient load bearing capacity.
CAUTION
Whichever mounting method is used, ensure that the
bracket is tightly and securely fastened to wall. Failure
to secure boiler properly could cause boiler to loosen,
posing a severe safety hazard.