Charging Steps; Troubleshooting - BorMann BBC4030 Manual

EN

Charging Steps

STEP 1: DIAGNOSIS (Check if battery has connected with the charger and also check battery voltage)
STEP 2: DESULPHATION (If battery voltage is too low, programs automatically generate pulsing current to remove sulphate, up to 10 minutes)
STEP 3: ANALYSE (Check if the battery voltage reaches to the threshold after desulphation, and charging begins if the battery voltage is OK)
STEP 4: SOFT START (Charge with echelon constant current)
STEP 5: BULK (Charge with constant maximum current until battery voltage is reached to the threshold)
STEP 6: ABSORPTION (Provide gradually declining current charge for maximum battery voltage)
STEP 7: ANALYSE (Test if the battery can hold charge)
STEP 8: MAINTENANCE (Continuously monitor the battery, and charging current will intelligently adapt to the variable battery voltage)

Troubleshooting

LCD DISPLAY
ERROR + OVERHEATING
ERROR + NO CONNECTION
ERROR + BATTERY
VOLTAGE MISMATCH
ERROR + BAD BATTERY
ERROR + REVERSE POLARITY
ERROR + OVERLOAD
EN
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of
the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses
or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
5
CAUSE
The charger is overheated
1) Open-circuit
2) Dirty Battery Posts
3) Dead Battery
4) Output Short Circuit
Charging in 12 V Mode(s) for 24 V battery
Battery cannot store energy or cannot be
recovered through Repair Mode
Reverse Polarity
Overload in SUPPLY Mode
(will automatically shut down
for 30 seconds as protection)
WWW.BORMANNTOOLS.COM
SOLUTION
The charging will automatically pause. Do NOT cut off the
power supply, and the charger will work again when cooled
down.
1) Connect the red and black clamps to the battery posts
2) Clean the battery posts
3) Replace the battery with a new one immediately
4) Disconnect red and black output terminals
Restart the charger and choose the correct charge mode.
1) Replace the battery with a new one
2) If REPAIR Mode has not be tried, try it for recovery
Exchange the red and black clamps to
the correct battery posts
Disconnect the external device