Motorola L6Q Installation Manual page 33

3 Thread the two metal band ties through the slots on the top and bottom of the mounting bracket
with the buckles facing out.
4 Insert the ends of the pole straps into the buckles around the pole.
5 Slide the mounting bracket to its final position on the pole (facing the direction of traffic) and
tighten the metal band ties with the hex key tool.
6 Trim any excess material from the metal band ties with the wire snips.
7 Remove the reusable zip tie for later use.
8 Connect the M12 elbow connector from the power source to the lower port on the back of the
camera and screw down the connector sleeve to secure.
9 Insert the ball on the back of the camera into the ball socket on the mounting bracket and tighten
the ball joint enough to keep the camera in place, but still allow it to pivot.
10 To secure any power cables, use the two reusable zip ties.
11 Trim the excess material from the zip ties.
12 Remove the protective film from the camera lens.
3.5
Camera Aiming
Camera aiming is essential to maximize the license plate capturing performance of the camera. Proper
aiming ensures that license plates traveling through the camera's field of view are at an ideal height
and angle to generate an image that is as clear and readable as possible.
3.5.1
Preparing for Camera Aiming
L6Q includes a mobile phone holder to allow for one hand adjustment of the camera.
Procedure:
1 Slide the mobile phone into the included mobile phone holder and hook it onto the lower metal
band tie.
NOTE: Give the phone holder a light tug to ensure that it is securely hooked on the pole
strap before letting it hang.
3.5.2
Adjusting the Capture Zone
Prerequisites: When possible, use a test vehicle or hang a license plate in the road at vehicle height
to determine the best capture point. Further adjustments may be necessary to fine-tune aiming after
testing the camera's capture performance.
Procedure:
1 To adjust the aim, grip the camera firmly with one hand while watching the screen of the mobile
phone.
2 Adjust the camera until the green capture zone on the screen is centered on where the vehicle
license plates will be traveling through the roadway.
NOTE: When aiming for two lanes, center the green capture zone on the middle of the
roadway between the two lanes.
3 To lock the camera in place, tighten the ball joint.
MN008660A01-AA
Chapter 3 : Hardware Installation
33