Figure 7: Sim And Sd Card Slots; Figure 8: Battery Installation - Motorola L6Q Installation Manual

Figure 7: SIM and SD Card Slots

3 Align the SIM Card with the circuity facing up with the notch in the upper right corner.
4 Align the SD Card with the arrow facing towards the camera and the shim on the left.
5 Slide each card into its appropriate slot and gently press until it clicks.
6 Insert the battery as shown by sliding it into the battery compartment and secure the two security
screws with the Pin and Torx Tool.

Figure 8: Battery Installation

2.4
Charging the Camera
Procedure:
1 To unscrew the security screw in the power port door next to the battery compartment, use the
Pin and Torx Tool.
2 To charge the swappable battery of the camera, use the included USB-C Cable and power the
unit directly from a USB-A power source.
NOTE: Notice the location of the QR code above the USB-C port. Later, it is scanned to
pair the L6Q Camera to the Mobile Companion application.
3 Unfurl the USB-C Cable and plug it into a USB-A power source.
4 Plug the USB-C end into the charging port.
MN008660A01-AA
Chapter 2 : Getting Started
13