Toro Groundsmaster 4500-D Installation Instructions Manual page 15

Figure 23
1. Platform shroud
2. Headlight assembly
3. Carriage bolt (2)
16. Route the wire harness to the steering column.
The steering column connections will be installed
when the control console is installed.
17. Connect the brake connector to the main
harness under the platform near the brake
connections (Figure
18. Route the wire harness to the back of the
machine under the right side of the traction unit
(Figure 26).
19. Route the left wire connector under to the left, to
the rear light bracket.
20. Thread each rear light connector through the
appropriate rear light bracket
Figure 24
1. Left, rear-light connector
2. Right, rear-light connector
21. Align the 4-socket connector of the harness
through the inner mount
4. Self-tapping bolt (2)
5. Create a notch here.
6. Headlight connector
21).
(Figure 24).
3. License-plate connector
(Figure 25).
22. Assemble the inner mount into the light housing,
and secure the mount to the housing
with 4 socket-head screws (1/4 x 3/4 inch).
23. Align the taillight to the light housing with the
yellow lens positioned as shown in
24. Plug the 4-socket connector of the harness into
the 4-pin connector of the taillight
25. Assemble the taillight into the light housing, and
secure the light to the housing
Phillips-head screws (#10 x 1-1/4 inches).
g371181
1. Socket-head screw (1/4 x
3/4 inch)
2. Inner mount
3. Yellow lens (taillight)
g371711
4. Red lens (taillight)
26. Route the wire harness to the license-plate light
and plug the wire-harness connector into the
light connector
Important:
cable ties so that it does not contact any hot
or moving parts
15
Figure
(Figure
(Figure
Figure 25
5. 4-socket connector
(taillight harness)
6. Phillips-head screw (#10 x
1-1/4 inches)
7. Clip nut (#10)
(Figure 24).
Secure the wire harness with
(Figure 26).
(Figure 25)
25.
25).
25) with 2
g371798