Toro Groundsmaster 4500-D Installation Instructions Manual page 13

Figure 17
1. Compartment clamp
2. Remove the relays, fuse block, grounding block,
and fuse clip from the steel plate in the fuse
compartment next to the battery
Figure 18
1. Battery
2. Relays
3. Grounding block
g023198
2. Seal
(Figure 18).
g371793
4. Fuse clip
5. Module installed
6. Fuse block
3. Remove the bolts holding the steel plate in the
fuse compartment.
4. Locate the module on the wire harness
19).
Important:
When routing the wire harness,
do not pull it across sharp edges, which may
damage the wires. Wires must not contact
hot or moving parts. Secure the wire harness
with cable ties.
5. Route the whole wire harness through the
new steel plate and the hole located at the
compartment clamp
Route the wire harness until the module contacts
the steel plate.
1. Bolt (#8 x 1/2 inch)
2. Bracket
3. Connector on the bottom
of module
4. Existing bolt
13
(Figure 17 and Figure
Figure 19
5. New steel plate
6. Connectors from fuse
block
7. Module in the harness
8. Bolt (#8 x 1/2 inch)
(Figure
19).
g371430