Toro Groundsmaster 4500-D Installation Instructions Manual page 11

Figure 13
1. Inner mount
Note:
After routing the wire harness through the
light brackets, mount the rear-light assemblies to
inner mounts with 4 screws (#10 x 1-1/4 inches)
and nuts included with the light
6
Installing the License-Plate
Bracket
Parts needed for this procedure:
1 Plate light
1 Plate bracket
2 Screw (#10 x 1 inch)
2 Speed nut (#10)
2 Self-tapping screw (5/16 x 1/2 inch)
Procedure
1. Secure the plate light to the license-plate bracket
with 2 screws (#10 x 1 inch) and 2 locknuts
(Figure 14 and Figure
Note:
Do not overtighten the screws. Ensure
that the lens points downward and the wires are
inserted through the hole in the license-plate
bracket.
g371870
2. Clip nut (1/4 inch)
(Figure 25).
15).
1. Speed nut (#10)
2. Plate light
1. Speed nut (#10)
2. License-plate bracket
3. Plate light
2. Mount the license-plate bracket to the rear
bumper with 2 self-tapping screws (5/16 x 1/2
inch) as shown in
11
Figure 14
3. Screw (#10 x 1 inch)
Figure 15
4. Screw (#10 x 1 inch)
5. Self-tapping screw (5/16 x
1/2 inch)
Figure 15.
g371733
g371652