Toro Groundsmaster 4500-D Installation Instructions Manual page 16

Figure 26
1. Magnetic cable-tie mounts
27. Install any parts that were removed from the
traction unit to route the wire harness.
g371724
2. Cable tie
8
Installing the Control
Console
Parts needed for this procedure:
1 Switch mount assembly
1 Control cover
1 Fuse mount plate
3 Clip nut (#10)
1 Flasher
1 Flange head screw (#10 x 3/8 inch)
1 Cable tie
2 Bracket mount
8 Clip nut (1/4 inch)
1 Switch mount
1 Multi-function switch
1 Switch clip (thick)
1 Switch clip (thin)
3 Switch plug
1 Rocker switch
2 Knob
1 Fuse cover
2 Bolt retainer
4 Carriage bolt (1/4 x 2 inches)
4 Flange locknuts
2 Cable ties
2 Push-in fastener
6 Flange-heads screw (1/4 x 3/4 inch)
Assembling the Fuse Mount Plate
1. Align the connectors for the controls through the
previously made notch in the headlight assembly
(Figure 2).
2. Pull the boot down and assemble the bottom of
it into the steering cover.
3. Assemble the clip nut (#10) onto the fuse mount
plate (Figure 27).
16