Floating Block - Orca 500 Operating And Maintenance Instructions Manual

d. Rinse and clean the filter (4-5).
Put the filter under water until the water is clean.
e. Reinstall the filters.
Pay attention to the good position and close the covers by pressing the buttons.
4-6

3.2 Floating block

It is difficult for the cleaner to climb the wall and clean the water line. The following operation is not
necessary if the cleaner climbs the wall well.
Open the top cover and glue the float block at the position shown in the below picture. The other side is
also glued.
Note:
1. You can also glue the float block on the top cover without removing the cover. Touch the position with
your hands and glue it according to the picture.
2. The float block has glue on its back, so It has to be glued on the top cover tightly and then put it into the
pool 24 hours later.
Large face in the middle
45
4-5
Appuyer
4-7