Orca 500 Operating And Maintenance Instructions Manual page 37

2.1
Cautions
a. Power supply unit position
The power supply unit must be correctly positioned so that the device can reach all corners of
the pool and must be fixed at a minimum distance of 3.50 metres from the edge of the pool.
Before connecting the cleaning device to the power supply, check that the voltage and
frequency of your electrical network correspond to the instructions on the label on the
back of the power supply AND THAT YOUR INSTALLATION CONTAINS A
DIFFERENTIAL PROTECTION OF 30 MA.
2.2 Important !
a. To immerse the cleaner
Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible scratches
to the pool. Hold the top handle and put it into the pool. Let the cleaner immerse into the pool floor after
emptying the air inside it (the air inside should be exhausted completely, otherwise its normal working will
be affected).
3.0
To get the cleaner out of the water
Use the handle to remove the unit from the water, not the cable, otherwise the unit may be
damaged..
37