Table of Contents
Advertisement
Section 4
INTERIOR CLEANING
When cleaning interior and exterior of unit, care should
be taken to avoid the front power switch and the rear
power cord. Keep water and/or cleaning solutions away
from these parts.
Never use a high-pressure water jet for cleaning or hose
down or flood interior or exterior of units with water. Do
not use power cleaning equipment, steel wool, scrapers
or wire brushes on stainless steel or painted surfaces.
The interior can be cleaned using soap and warm water. If
this isn't sufficient, try ammonia and water or a nonabrasive
liquid cleaner.
Preventing Blower Coil Corrosion
To help prevent corrosion of the blower coil, store all acidic
items, such as pickles and tomatoes, in seal-able containers.
Immediately wipe up all spills.
Part Number: 9291514 04/17
Notice
Notice
EXTERIOR CLEANING
Never use an acid based cleaning solution on exterior
panels! Many food products have an acidic content,
which can deteriorate the finish. Be sure to clean the
stainless steel surfaces of ALL food products.
Clean the area around the unit as often as necessary to
maintain cleanliness and efficient operation.
Wipe surfaces with a damp cloth rinsed in water to remove
dust and dirt from the outside of the unit. Always rub with
the "grain" of the stainless steel to avoid marring the finish.
If a greasy residue persists, use a damp cloth rinsed in a
mild dish soap and water solution. Wipe dry with a clean,
soft cloth.
Never use steel wool or abrasive pads for cleaning. Never
use chlorinated, citrus based or abrasive cleaners.
Stainless steel exterior panels have a clear coating that
is stain resistant and easy to clean. Products containing
abrasives will damage the coating and scratch the panels.
Daily cleaning may be followed by an application of
stainless steel cleaner which will eliminate water spotting
and fingerprints. Early signs of stainless steel breakdown
are small pits and cracks. If this has begun, clean thoroughly
and start to apply stainless steel cleaners in attempt to
restore the steel.
Door Gasket Maintenance
Door gaskets require daily cleaning to prevent mold
and mildew build up and also to retain the elasticity of
the gasket. Gasket cleaning can be done with the use of
warm soapy water. Avoid full strength cleaning products
on gaskets as this can cause them to become brittle and
crack. Never use sharp tools or knives to scrape or clean
the gasket. Gaskets can be easily replaced and do not
require the use of tools or an authorized service person. The
gaskets are "Dart" style and can be pulled out of the groove
in the door. Soak new gaskets in warm water to make them
more pliable. Dry and "press" back into place.
Casters
Wipe casters with a damp cloth monthly to prevent
corrosion.
Maintenance
Notice
13
Advertisement
Table of Contents
