Figure 3-19: Ie-78K0-Ns-A Side - NEC IE-78K0-NS-P04 User Manual

<2> Prepare the IE-78K0-NS-P04.
<3> Remove the crystal oscillator that is mounted in the IE-78K0-NS-P04's socket (the socket marked
as "X1").
<4> Connect the parts board (from <1> above) to the socket (X1) from which the crystal oscillator was
removed (see <3> above). Check the pin 1 mark to make sure the board is mounted in the correct
direction.
<5> Install the IE-78K0-NS-P04 and the IE-780948-NS-EM4 in the IE-78K0-NS-A.
The above steps configure a circuit and enable clock output to be supplied from the mounted oscilla-
tor to the emulation device.
3
CA
12
Remark: The section enclosed in broken lines indicates parts that are attached to the parts board.
IE-78K0-NS-P04, IE-780948-NS-EM4

Figure 3-19: IE-78K0-NS-A side

10 MΩ
HCU04 HCU04
9 8
5
Rx
10
4 11
13
CB
2
JP8
1 2
3 4
Target
5 6
system
CLK IN
43