Uniz SLASH 2 PLUS User Manual page 24

3. Push the Build Platform down until it comes into contact with the LCD.
4. Place four pieces of paper under four corners of Build Platform then push down Build Platform
to touch LCD screen. At this time, there is at least one pieces of paper is pressed between Build
Platform and LCD screen (which means this corner is in good position).
5. Select a corner where the paper is loose. Use screwdriver to loosen screw by turning anti-
clockwise and pull and push paper. When the paper cannot be pulled, it means this corner touch
the screen closely and in good position. Use the same method to adjust other corners and ensure
all corners are pressed firmly.
D USAGE AND MAINTENANCE
18