Uniz SLASH 2 PLUS User Manual page 23

3. Clean the platform with alcohol again to make sure there is no residue left.
4. Calibrate the Z-axis zero position.
CLEANING PLATFORM
Use the scraper delivered with the printer to remove the residues (please deal with solidified
materials and waste resin properly).
Notes:
After removal of model, please clean Build Platform thoroughly, any leftover bits may
damage the Resin Tank or LCD.
RESET Z-AXIS ZERO POSITION AND LEVELING BUILD PLATFORM
1. Prepare four pieces of paper and a cross screwdriver.
2. Tighten four screws with cross screwdriver by turning clockwise.
D USAGE AND MAINTENANCE
17