Accessories - Dometic 10 Series Installation Manual

Accessories

• Do not open or damage the refrigerant circuit under any circum-
stances.
A
NOTICE! Damage hazard
• Only hold the device at the body of the device during transport. Never
hold the device at the absorber unit, the cooling fins, the gas pipes,
the door or the control panel.
• Do not install the device near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
• Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
• Check that the voltage specification on the data plate is the same as
that of the power supply.
• Only use the AC connection cable supplied to connect the device to
the AC mains.
• Only use cables with a suitable size.
• Never pull the plug out of the socket by the connection cable.
• The device may not be exposed to rain.
!
3 Accessories
Description
Flexible gas piping
Seal for draft-proof installation for gaps of 1 – 5 mm (fig. 9 B, page 7)
Seal for draft-proof installation for gaps of 5 – 10 mm (fig. 9 C, page 7)
Winter cover WA 130 for the ventilation grille LS 200
Adapter cable
• WAGO to CEE
• WAGO to UK
• WAGO to JST
• WAGO to MATE-N-LOK
Optional Fan Kit REF-FANKIT
18
RM10.5(S)(T), RMS10.5(X)(S)(T)
EN