10.2. CDP control panel functions
The CDP control panel serves as the basic user interface for operating and monitoring the
drive when the local operating mode has been selected.
The CDP control panel can be attached to or detached from the drive without having to
switch off the auxiliary power supply first.
You can perform the following tasks with the CDP control panel:
– Enter start-up data
– Control the drive with a reference value, and start, stop and direction commands
– Display actual values (three values can be read simultaneously)
– Display and adjust parameters
– Display information on the most recent forty fault events
– Upload and download complete parameter sets from one drive to another
10.3. CDP control panel modes
The CDP control panel provides the following modes:
– Identification mode, page 102
– Actual signals mode, page 103
– Parameters mode, page 110
– Functions mode, page 115
10.3.1. Identification mode
The identification mode informs the user about the CDP control panel version and the ID
number of the drive. The information appears on the display when the:
– Power supply is switched on
– CDP control panel is connected to the drive and the auxiliary voltage has already been
switched on.
When the CDP control panel is initialized as described before, the display changes as
follows:
CDP312 PANEL V5.30
........
PRODUCT
ACS1000i
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS206977 E01
CDP CONTROL PANEL
REV.
LANG.
PAGE
J
en
102/146