Related Manuals for Eurolux ERU52X
Summary of Contents for Eurolux ERU52X
- Page 1 INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS FOR EUROLUX RANGEHOOD Model: ERU52X ERU70X ERU90X AUSTRALIAN & NEW ZEALAND PRODUCT WARRANTY...
-
Page 2: Table Of Contents
ERU52X/ERU70X/ERU90X CONGRATULATIONS Welcome to the Eurolux Kitchen Community and thank you for choosing one of our many fantastic appliances. Before you use the rangehood we strongly recommend that you read through the whole user manual which provides the description of this product and the proper use of its functions. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Important: Please read the entire instructions before installing the rangehood. Check appliance for damage or missing parts (if damaged, do not install). • Always switch power off prior to installation. • All electrical work must be done in accordance with local and national electrical codes as applicable. •... -
Page 4: Appliance Details
APPLIANCE DETAILS 520 700 900 497 677 865 Φ150... - Page 5 APPLIANCE DETAILS...
-
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS Here two venting modes, extraction-air mode and recirculation mode, before installing, select one mode. Recirculation mode Extraction-air mode • Press the lock catch of metal Filter, remove the Filter. • Remove the stainless steel frame by unfastening the 4 screw (M4*10). and ERU90X model unfastening the other 2 screws (M4*8). - Page 7 INSTALLATION INSTRUCTIONS • Unfastening the screws (ST4*10), remove the lid of terminal box, disconnect the wires to the Commands at the connectors. • Disconnect the wires to the Light at the connectors. • Fasten the Hood in the cabinet by using the 12 screws (ST4*18). •...
- Page 8 INSTALLATION INSTRUCTIONS • Reconnect the wires to the Commands and Light. • Replace the metal Filter. • Install the air outlet pipe(optional).
-
Page 9: Operating Instructions
OPERATING INSTRUCTIONS Speed adjustment : • Press the Light button, the two lighting lamps will come on. • Press it again and the lamps will be turned off. • Press the High (speed) button, the motor runs at high speed •... -
Page 10: Maintenance And Cleaning
MAINTENANCE AND CLEANING GREASE FILTERS • Removing the metal filter according to Installation. • Put it into a dishwasher with detergent, set the temperature below 60 degrees. • Please do not use abrasive detergent for it will damage the hood. •... - Page 11 REPLACING THE LAMP • Press the lock catch of the metal filter and remove the filter. • Push the lamp from inside to remove the lamp. • Disconnect the wires from the lamp. • Connect the wires to the new lamp. •...
-
Page 12: Troubleshooting
TROUBLESHOOTING Fault Cause Solution The blades are blocked. Check the blades. The capacitor is damaged. Replace capacitor. Light on, but motor does not The motor is damaged. Replace motor. work The internal wiring of motor is cut off/ disconnected. An Replace motor. -
Page 13: Australian & New Zealand Product Warranty
WHAT IS COVERED: By Our Warranty During the warranty period, Eurolux or its authorised Service Centre will at no extra charge, if your appliance is readily accessible without the need of special equipment and subject to the terms and conditions of this warranty, repair or replace any parts which it considers defective. - Page 16 A division of Shriro Australia Pty Limited 2-34 Davidson Street, Greenacre NSW 2190 AUSTRALIA: 1300 355 541 www.shriro.com.au NEW ZEALAND: (09) 415 6000 www.monacocorp.co.nz IM Ref: ERU52X/ERU70X/ERU90X 3/2021/15FC FOR INDOOR USE ONLY EASY DECISION...