Assembly - Gravely Tratch-O-Matic Owner's/Operator's Manual

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
The Power Rake covered in this owner's
guide is shipped complete in one box. Follow
all instructions on assembly very carefully.
Carton Contents
• Unit
• Literature Pack

ASSEMBLY

1. Remove all items from carton.
2. Tip box over so wheels are toward floor.
Pull unit out of box and stand upright.
IMPORTANT: DO NOT discard the carton or
any of the inserts until the unit is completely
assembled.
3. All hardware is on the unit in its proper
location. If something is missing, notify
the dealer/distributor where unit was
purchased. If unable to purchase parts
locally, contact Gravely.
NOTE: Left or right side of the machine is
determined when standing behind the unit
and in the operator's position.
HANDLE ASSEMBLY
Figure 3
1. Remove four hex nuts, lock washers and
contour head bolts from lower end of
upper handle.
2. Place upper handle down over small
diameter end of lower handles.
3. Align lower holes in upper handle and
lower handle. Insert contour head bolt
through each hole.
4. Lift handle back brace on each side so it
is assembled to contour head bolt.
Assemble one lock washer and hex nut
to each bolt. Do not tighten.
5. Insert remaining contour head bolts
through upper holes of upper and lower
handles.
6. Assemble lock washers and hex nuts to
upper contour head bolts and tighten all
nuts.
ASSEMBLY
Upper Handle
Contour
Head Bolts
Safety Bail Assembly
Figure 4
1. Remove hex bolt and hex lock nut from
curved bracket on the upper handle
assembly.
2. Straighten the cable and route it up left
hand side of handle.
3. Attach cable to curved bracket center
hole using hex bolt and lock nut.
Cable
GB - 8
Washers
Hex Nut
Lower Handle
Figure 3
Hex Bolt & Hex
Nut
Figure 4
Hex
Nut
Lock