Remove the roller brush.
Pull the bearing cover off the roller
brush and remove any threads or
hairs that have wound themselves
around the bearing.
Refit the bearing cover, making sure it
clicks into position.
Cut any threads or hairs that have
wound themselves around the roller
brush with a pair of scissors.
Remove the threads and hair using
the wiper which is located on the
bottom of the cleaning tool.
Hold the wiper over a bin.
Press the button at the top of the
wiper several times until all threads
and hair have fallen out.
Refit the roller brush with the bearing
cover attached. Make sure that the
side with the pointed end is inserted
into the corresponding slot.
Carefully refit the roller brush cover
on both sides, making sure it clicks
into position.
Refit the side brushes, see "Cleaning
the side brushes".
In order to continue to achieve the
best possible cleaning results,
replace the roller brush with a new
one after approx. 1 year.
Cleaning the dust box seals
Clean the seals on the bottom of the
dust box as required.
Place the robot vacuum cleaner
upside down on a level, clean
surface.
33