lopital Elexo XXL Instructions For Use Manual page 16

Only the original charger for the Elexo XXL may be used. If you use another
charger, Lopital cannot be held liable for any consequences, such as damage to
the electronics.
Once the charger is connected to the Elexo XXL, the controls will go into 'sleep'
setting (all functions are switched off).
The charger that must be used for the Elexo XXL is the 'Mascot 2241'.
• When the indicator light on the charger goes
green, the battery is charged .
The charger can remain connected even when
the battery is completely charged . Leaving it
connected will not cause any damage .
• Disconnect the Elexo XXL from the charger .
• Once activated, the Elexo XXL is now ready for
use (See paragraph 2.2. Activating) .
LED not on:
Green LED is on:
Orange LED is on:
Orange LED blinks:
Red LED blinks:
Red LED on:
Charge battery in a well-ventilated, dry space.
After using the chair, connect it to the charger to maintain the battery.
Charge the chair at least once a week!
For instruction videos go to www .lopital . c om or www . y outube . c om/user/LopitalNL
16 | Instructions for use | Elexo XXL Shower-toilet chair
Chair is in 'sleep' setting and cannot be used .
Chair is ready for use .
Battery needs charging or battery is partially charged .
Emergency stop has been activated .
Battery must be charged (chair can still be used) .
Battery is completely empty and must be charged immediately .
Figure 16 Battery indication on manual
control .