Configuring A Static Ip Address For The Bmc; Configuring A Bmc Static Ip Address Using Ipmitool - Nvidia DGX A100 User Manual

https://apt.dockerproject.org/repo/

https://download.docker.com/linux/ubuntu/

https://nvcr.io/

To verify connection to nvcr.io, run the following command:
$ wget https://nvcr.io/v2
You should see connecting verification followed by a 401 error.
--2018-08-01 19:42:58-- https://nvcr.io/v2
Resolving nvcr.io (nvcr.io)... 52.8.131.152, 52.9.8.8
Connecting to nvcr.io (nvcr.io)|52.8.131.152|:443... connected.
HTTP request sent, awaiting response... 401 Unauthorized
7.5 Configuring a Static IP Address for
the BMC
This section explains how to set a static IP address for the BMC. You will need to do this if your
network does not support DHCP.
Use one of the methods described in the following sections:

"Configuring a BMC Static IP Address Using ipmitool"


"Configuring a BMC Static IP Address Using the System BIOS"

7.5.1 Configuring a BMC Static IP Address Using
ipmitool
This section describes how to set a static IP address for the BMC from the Ubuntu command
line.
•
Note: If you cannot access the DGX A100 System remotely, then connect a display (1440x900
or lower resolution) and keyboard directly to the DGX A100 system.
To view the current settings, enter the following command.
$ sudo ipmitool lan print 1
To set a static IP address for the BMC, do the following.
Set the IP address source to static.
1.
$ sudo ipmitool lan set 1 ipsrc static
Set the appropriate address information.
2.
To set the IP address ("Station IP address" in the BIOS settings), enter the following
•
and replace the italicized text with your information.
$ sudo ipmitool lan set 1 ipaddr <my-ip-address>
DGX A100 System
Network Configuration
DU-09821-001_v06 | 44