Replacement Parts; Troubleshooting - Porter-Cable C6110 Instruction Manual

REPLACEMENT PARTS

REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our
service website at www.deltaportercableservicenet.com. You can also order parts
from your nearest PoRTeR-Cable Factory Service Center or PoRTeR-Cable
Authorized Warranty Service Center. Or, you can call our Customer Care Center at
1-(888)-848-5175.
SERVICE AND REPAIRS
all quality tools will eventually require servicing and/or replacement of parts. For infor-
mation about PoRTeR-Cable, its factory service centers or authorized warranty ser-
vice centers, visit our website at www.deltaportercable.com or call our Customer Care
Center at 1-(888)-848-5175. all repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
You can also write to us for information at PoRTeR-Cable, 4825 Highway 45 North,
Jackson, Tennessee 38305 - attention: Product Service. be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number,
etc.).
Since accessories, other than those offered by PoRTeR-Cable, have
not been tested with this product, use of such accessories with this tool could be haz-
ardous. To reduce the risk of injury, only PoRTeR-Cable recommended accessories
should be used with this product.
a complete line of accessories is available from your PoRTeR-Cable Factory Service
Center or a PORTER­CABLE Authorized Warranty Service Center. Please visit our Web
Site www.deltaportercable.com for a catalog or for the name of your nearest supplier.
Risk of Unsafe Operation. Unit cycles automatically when
power is on. When servicing, you may be exposed to voltage sources,
compressed air, or moving parts. Before servicing unit unplug or disconnect
electrical supply to the air compressor, bleed tank of pressure, and allow the
air compressor to cool.
PROBLEM
excessive
tank pressure
- safety valve
pops off
air leaks at
fittings
ACCESSORIES

TROUBLESHOOTING

CAUSE
Pressure switch does
not shut off motor when
compressor reaches
"cut-out" pressure.
Pressure switch "cut-
out" too high.
Tube fittings are not
tight enough.
SERVICE
Move auto/off lever to the "off"
position, if the unit does not shut off
contact a Trained Service Technician.
Contact a Trained Service Technician.
Tighten fittings where air can be
heard escaping. Check fittings
with soapy water solution. Do
NoT oVeR TIGHTeN.
17 - eNG
CORRECTION