Polaroid P751 User Manual page 20

General Info.
Getting Started
Operation
Printing a Card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
12
C - CARD THICKNESS CONTROL LEVER
This item is operated by the user to prevent more than one card feeding
into the printer at the same time and causing a jam.
Card Thickness:
A - 60mil (1.524mm) to 50mil
(1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
D - 20mil (0.5mm)
E - < 20mil (0.5mm)
For other card thickness, start lever
at lowest position and move up
until cards feed.
* Start at lowest position and move lever up to match card thickness.
D - CARD OUTPUT HOPPER
For collecting printed cards.
P75i
User's Manual
Open Cover, and adjust lever to correct
position. Repeat for different card thickness.
(Factory setting is for 30mil (0.762mm) card
thickness. See diagram below:
Install Card Output Hopper onto printer by
hooking over bottom edge of card exit
aperture.