Declarations Of Conformity - Polaroid P751 User Manual

General Info.
Getting Started
Operation
Printing a Card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
III

DECLARATIONS OF CONFORMITY

89/336/EEC
EMC Directive
modified by
EMC Directive
92/31/EEC and
93/68/EEC EMC Directive
73/23/EEC modified Low voltage
by 93/68/EEC Directive
1999/5/CE
R&TTE Directive
For a formal Certificate, please contact Compliance Engineering at the Fort Wayne facility.
Model: P75i conforms to the following specification:
FCC Part 15, Subpart A, Section 15.107(a) and Section 15.109(a) Class B digital device
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference's by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet, prepared by the Federal Communications
Commission, helpful:
How to identify and resolve Radio/TV Interference Problems. This booklet is available from
the U.S. Government printing Office, Washington, D.C. 20402, Stock No. 004-000-00345-4.
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment
not expressly approved by Polaroid may cause harmful interference and void the FCC
authorization to operate this equipment.
INDUSTRY CANADA NOTICE
This device complies with Industry Canada ICS-003 class B requirements.
P75i
User's Manual
RF Emissions control
EN 55022 (1998)
EN 301489-3 V1.4.1 RF Emissions and immunity for radio equipment
EN 55024 (2001) Immunity to Electromagnetic Disturbances
EN 60950 (1992) and
Product safety
Amendments A1 to
A11 (1997)
Radio frequency interferences
EN300330-2 V1.1.1