The front shock in packing situation is as below picture about.
1-
Remove pin, nut, adjusted cushion from the
bolt on the tie rod.
2-
Insert the bolt on the tie rod into the hole on
the front wheel axle.
3-
Tighten the nut, insert the pin, then lock the
pin.
4-
Put the upper hole of the front shock into
the groove on the frame.
5-
Insert the bolt though the hole on the
groove and the hole on the front shock.
(Notice; one cushion on one side
of hole on the front shock.)
6-
Tighten the nut.
ATTACH FRONT SHOCK