Led Indications; Switch Rear Panel; Install The Switch - Planet WGSW-2840 User Manual

2.1.3 LED Indications

WGSW-2840:
LED Color
PWR Green
SYS Green
LNK/ACT Green
Speed Orange
WGSW-5240:
LED Color
PWR Green
SYS Green
LNK/ACT Green

2.1.4 Switch Rear Panel

Figure 2-2 shows the rear panel of the switch
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks
should active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your switch from being
damaged by unregulated surge or current to the Switch or the power adapter.

2.2 Install the Switch

This section describes how to install the Ethernet Switch and make connections to it. Please read the
following topics and perform the procedures in the order being presented.
Function
Lights to indicate that the Switch is powered on.
Lights to indicate the system is working.
Blink to indicate that the switch is actively sending or receiving data over that
port.
Lights to indicate the link through that port is successfully established.
Function
Lights to indicate that the Switch is powered on.
Lights to indicate the system is working.
Lights to indicate the port is linked.
Blinks to indicate that the switch is actively sending or receiving data over that
port.
Figure 2-3 WGSW-2840 rear panel
Figure 2-4 WGSW-5240 rear panel