Page 1
Serial number: Date of purchase: Winton Rotovator Factory reference: IGN125 / IGN150 WRT Series This manual should be considered a permanent part of this attachment and therefore should remain with it even if the attachment is subsequently sold. The manufacturer continually seeks advancements in its product design and quality.
Page 2
Safety Information Safety Information (Continued) Before installation/maintenance, ensure both tractor and Attachment Pre-use Checks attachment are stationary, with the hydraulic lift system in a neutral Upon receipt of attachment, and again within the first 4 hours of use: position and the ignition key removed. Read and understand this manual fully before operating machinery.
Installation Installation (Continued) Before installation/maintenance, ensure both tractor and Always couple the two ends of the driveline and check they are locked in attachment are stationary, with the hydraulic lift system in a neutral place. Completely insert the sprung lock pins (1) into the grooves in the position and the ignition key removed.
Blade Replacement Gearbox Oil Change & Check Before installation/maintenance, ensure both tractor and attachment Before installation/maintenance, ensure both tractor and are stationary, with the hydraulic lift system in a neutral position and attachment are stationary, with the hydraulic lift system in a neutral the ignition key removed.
Gear Reservoir Oil Change Rear Guard Adjustment Before installation/maintenance, ensure both tractor and Before installation/maintenance, ensure both tractor and attachment are stationary, with the hydraulic lift system in a neutral attachment are stationary, with the hydraulic lift system in a neutral position and the ignition key removed.
Tilling Depth Adjustment Servicing & Maintenance Before installation/maintenance, ensure both tractor and Store all lubricants away from excessive heat, dust, moisture and attachment are stationary, with the hydraulic lift system in a contaminants. Before maintenance, ensure both tractor and neutral position and the ignition key removed. attachment are stationary, with the hydraulic lift system in a neutral position and the ignition key removed.
Attaching & Resizing PTO Shaft Parts Diagram 1 Before installation/maintenance, ensure both tractor and attachment are stationary with the ignition key removed. Ensure all safety guards are in place and cover the PTO shaft when extended, ensure the sprung locking collar slides freely and is securely in the groove on the PTO.
Parts List 1 (Continued) Parts List 1 Diag Diag. Number Part Number Part Description Number Part Number Part Description 803170002 1G-125.01.001 125 gear box and transmission 32-3 703190125 1G-150.00.102 125 right blade 32-4 703190125 1G-150.00.102 150 right blade 803190150 1G-150.01.001 150 gear box and transmission 33-2 803190051...
Trouble Shooting Parts List 2 Issue Solution Diag Number Part Number Part Description Check all nuts and bolts are tightened. Check the oil Transmission gearbox level in gear guard and top up if required. Add Noisy attachment 703170191 1G-125.01.109 Drive shaft (L620.5) 125 grease to rotor bearing through grease point.
Terms & Conditions All products purchased as new are covered under our 12 month warranty from the date of purchase. During this period Winton will repair or replace defective parts free of charge. This warranty is given on the proviso that the product has been used and maintained according to the Owners Manual.
Need help?
Do you have a question about the WRT Series and is the answer not in the manual?
Questions and answers